Table of Contents
Advertisement
Hardware
1-2 (int): Power supply from JTAG interface
Jumpers JP5 to JP10
Close 1-2 to debug in Spy-Bi-Wire mode
Close 2-3 to debug in 4-wire JTAG mode
Orient Pin 1 of
MSP430 device
Jumper JP2
Open to disconnect LED
LED connected to P1.0
For bootloader use, the BSL connector and only one of the resistors R10 or R11 must be populated. If
the board is supplied internally, R11 (0 Ω) must be assembled. If the board is supplied externally, R10
(0 Ω) must be assembled, and R11 must be removed.
126
MSP430™ Hardware Tools
Jumper JP3
2-3 (ext): External power supply
Connector JTAG
For JTAG Tool
D1
Figure B-61. MSP-TS430PN80A Target Socket Module, PCB
Copyright © 2020 Texas Instruments Incorporated
Jumper JP1
Open to measure current
Connector BOOTST
For Bootloader Tool
Note
SLAU278AG – MAY 2009 – REVISED DECEMBER 2020
www.ti.com
Connector J5
External power connector
Jumper JP3 to "ext"
Connector J6
If the system is supplied from LDOI,
close JP4 and set JP3 to external
Submit Document Feedback
Advertisement
Table of Contents
