Table of Contents
Advertisement
Hardware
Connector BSL
For Bootloader
BSL Interface Select
Jumper J16
2
Close 1-2 for I C
Close 2-3 for UART
Connector J2
External power connector
Jumper J1 to "ext"
Jumper JP1, JP2
Open to measure
digital or analog current
Switch SW2
Connected to P1.3
LEDs connected to
P1.0, P1.1, P1.2 from
JP9, JP10, JP11
(only D1 assembled)
This target board supports UART or I C BSL configuration. To select the configuration to use, set the
jumpers as shown in the following table.
Jumper Configuration
JP17 and JP18
JP16
108
MSP430™ Hardware Tools
BSL Tool Select
Jumper JP13 to JP15
Open = BSL Connector
Close = JTAG Connector
10
1
2
R15
R7
30
U1
50
2
UART BSL Configuration
Close 2-3 (UART)
Figure B-51. MSP-TS430PM64F Target Socket Module, PCB
Copyright © 2020 Texas Instruments Incorporated
Connector JTAG
For JTAG Tool
Close JP17 and JP18
to enable BSL pullups
14
1
2
25
20
J4
Clamshell
IC51-0644-807
55
60
J6
2
I C BSL Configuration
Open
Close 1-2 (I2C)
SLAU278AG – MAY 2009 – REVISED DECEMBER 2020
Jumper J1
1-2 (int): Power supply from JTAG interface
2-3 (ext): External power supply
Jumper JP3 to JP8
Close 1 -2 to debug in Spy-Bi-Wire mode
Close 2-3 to debug in 4-wire JTAG mode
Switch SW1
Device reset
Orient Pin 1 of MSP430 device
HF and LF oscillators with capacitors
and resistors to connect pinheads
Close
Submit Document Feedback
www.ti.com
Advertisement
Table of Contents
