Texas Instruments MSP430 Series User Manual page 132

Hardware
1-2 (Debugger): Power supply from JTAG Interface
2-3 (External): External power supply
Connector J2
External power connector
Jumper J1 to External
Jumpers JP5 to JP10
Close 1-2 to debug in Spy-Bi-Wire mode
Close 2-3 to debug in 4-wire JTAG mode
Jumpers JP1 to JP4
Open to measure current
132 MSP430™ Hardware Tools
Jumper J1
Figure B-65. MSP-TS430PN80C Target Socket Module, PCB
Copyright © 2020 Texas Instruments Incorporated
Connector JTAG Connector BSL
For JTAG Tool For Bootloader Tool
SLAU278AG – MAY 2009 – REVISED DECEMBER 2020
www.ti.com
BSL Interface Switches
Select which BSL interface to connect to
connector BSL
I2C pullup enable switch
Switch On to connect I2C pullup resistors
Orient Pin 1 of MSP430 device
Jumpers JP11 and JP12
Open to disconnect LEDs D1 and D2
D1, D2
LEDs connected to P1.0, P1.1
Submit Document Feedback