Texas Instruments MSP430 Series User Manual page 157

www.ti.com
1-2 (Debugger): Power supply from JTAG interface
2-3 (External): External power supply
Connector J2
External power connector
Jumper J1 to External
Jumpers JP5 to JP10
Close 1-2 to debug in Spy-Bi-Wire mode
Close 2-3 to debug in 4-wire JTAG mode
Jumpers JP1 to JP4
Open to measure current
Figure B-79. MSP-TS430PZ100E Target Socket Module, PCB
SLAU278AG – MAY 2009 – REVISED DECEMBER 2020
Submit Document Feedback
Jumper J1
Connector JTAG
For JTAG Tool
Copyright © 2020 Texas Instruments Incorporated
Connector BSL
For Bootloader Tool
BSL Interface Switches
Select which BSL interface to connect
to connector BSL
I2C pullup enable switch
Switch On to connect I2C pullup resistors
Orient Pin 1 of MSP430 device
Jumpers JP11, JP12
Open to disconnect LEDs D1 and D2
D1, D2
LEDs connected to P1.0, P1.1
MSP430™ Hardware Tools
Hardware
157