Texas Instruments MSP430 Series User Manual page 27

www.ti.com
12.The device current is higher then expected. The device current measurement may not be accurate with
the debugger connected to the device. For accurate measurement, disconnect the debugger. Additionally
some unused pins of the device should be terminated. See the Connection of Unused Pins table in the
device's family user's guide.
13.MSP-FETv2 – SBW may have issues with some target socket boards. Check the capacitance of the RST
(SBWTDIO) line. If there is no capacitance, you may need to add at least 100 pF to the RST signal. The
additional capacity on the RST line ensures that the timing between the SBWTDIO and SBWTCK signals is
synchronized.
14.The following ZIF sockets are used in the FET tools and target socket modules:
• 8-pin device (D package): Yamaichi IC369-0082
• 14-pin device (PW package): Enplas OTS-14-065-01
• 14-pin package for 'L092 (PW package): Yamaichi IC189-0142-146
• 24-pin package (PW package): Enplas OTS-24(28)-0.65-02
• 28-pin device (DW package): Wells-CTI 652 D028
• 28-pin device (PW package): Enplas OTS-28-0.65-01
• 38-pin device (DA package): Yamaichi IC189-0382-037
• 40-pin device (RHA package): Enplas QFN-40B-0.5-01
• 40-pin device (RSB package): Enplas QFN-40B-0.4
• 48-pin device (RGZ package): Yamaichi QFN11T048-008 A101121-001
• 48-pin device (DL package): Yamaichi IC51-0482-1163
• 64-pin device (PM package): Yamaichi IC51-0644-807
• 64-pin device (RGC package): Yamaichi QFN11T064-006
• 80-pin device (PN package): Yamaichi IC201-0804-014
• 100-pin device (PZ package): Yamaichi IC201-1004-008
• 128-pin device (PEU package): Yamaichi IC500-1284-009P
Enplas: www.enplas.com
Wells-CTI (Sensata Technologies):
Yamaichi: www.yeu.com
SLAU278AG – MAY 2009 – REVISED DECEMBER 2020
Submit Document Feedback
www.sensata.com
Copyright © 2020 Texas Instruments Incorporated
Frequently Asked Questions and Known Issues
MSP430™ Hardware Tools 27