W4: Grinding-specific tool offset and monitoring functions - only 840D sl
18.5 Grinding-specific tool monitoring
18.5
Grinding-specific tool monitoring
18.5
18.5.1
General information
Activation
The tool monitoring function is a combination of geometry and speed monitors and can be
activated for any grinding tool (tool type: 400 to 499).
Selection
The monitoring function is selected:
● by programming (TMON) in the part program
● automatically through selection of tool length compensation of a grinding tool with uneven
Monitoring active
The monitor for a grinding tool remains active until it is deselected again by means of
program command TMOF.
Note
Monitoring of one tool is not deselected if the monitoring function is selected for another tool
provided the two tools are referred to different spindles.
One tool and thus also one tool monitor can be active for every spindle at any point in time.
Activated monitors remain active after a RESET.
1002
or
tool type number.
Note
The automatic selection of the monitoring must be set via the channel-specific machine
data:
MD20350 $MC_TOOL_GRIND_AUTO_TMON.
Function Manual, 09/2009, 6FC5397-1BP20-0BA0
Extended Functions