DB31, ...
DBB68
Axis/spindle replacement
Bit 7:
Signal state 0 or
edge change 1 → 0
Corresponding to ....
DB31, ... DBB8 (Axis/spindle replacement)
MD20070 $MC_AXCONF_ASSIGN_MASTER_USED
(Machine axis number valid in channel)
MD30550 $MA_AXCONF_ASSIGN_MASTER_CHAN
(Initial setting of channel for axis replacement)
Special cases, errors,
...
19.7
Kinematic transformation
19.7
19.7.1
Signals from channel (DB21, ...)
DB21, ...
DBX33.6
Transformation active
Edge evaluation: No
Signal state 1 or
The NC command TRANSMIT, TRACYL, TRAANG or TRAORI is programmed in the part program.
edge change 0 → 1
The corresponding block has been processed by the NC and a transformation is now active.
Signal state 0 or
No transformation active.
edge change 1 → 0
References
/PGA/ Programming Manual Job Planning
/FB3/ Function Manual, Special Functions; 3- to 5-Axis Transformation (F2).
Extended Functions
Function Manual, 09/2009, 6FC5397-1BP20-0BA0
PLC axis/spindle
Signal(s) updated: Cyclic
Z2: NC/PLC interface signals
19.7 Kinematic transformation
1063