Setting Remote Control Codes - Yamaha RX-V359 Owner's Manual

Setting remote control codes

You can control other components by setting the
appropriate remote control codes. You can set the remote
control codes for each input source. For a complete list of
available remote control codes, refer to "LIST OF
REMOTE CONTROL CODES" at the end of this manual.
The following table shows the default component
(Library: component category) and the remote control
code for each input source.
Remote Control Code Default Settings
Library
Input
(component
source
category)
CD CD
MD/CD-R CD-R
TUNER
TUNER
1
*
DVD DVD
DTV/
–
CBL*2
VCR –
V-AUX –
*1
You can control this unit only.
*2 You can only set TV remote control codes in DTV/CBL.
Note
You may not be able to operate your YAMAHA component even
if a YAMAHA remote control code is initially set as listed above.
In this case, try setting other YAMAHA remote control codes.
Default
Manufacturer
code
YAMAHA 199
YAMAHA 499
YAMAHA Fixed
YAMAHA 699
– –
– –
– –
1
While holding down CODE SET, press one of
the input selector buttons to select the
component you want to set up.
While holding
down
CODE SET
Note
You need to hold down CODE SET throughout this procedure.
2
While holding down CODE SET, press the
numeric buttons (0 to 9) to enter the three-
digit remote control code for the component
to be used.
Refer to "LIST OF REMOTE CONTROL CODES"
at the end of this manual.
While holding
down
CODE SET
Notes
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
• You can only assign one remote control code to each input
selector button.
REMOTE CONTROL FEATURES
CD MD/CD-R
DVD DTV/CBL VCR V-AUX
2CH STEREO MUSIC ENTERTAIN MOVIE
1 2 3 4
STANDARD 5CH STEREO
5 6 7 8
A SPEAKERS B
9 0
59