Yamaha RX-V359 Owner's Manual page 28

PLAYBACK
5
Rotate VOLUME on the front panel (or press
VOLUME +/– on the remote control) to adjust
the volume to the desired output level.
VOLUME
Note
If you connected a recording component to the VCR OUT,
or MD/CD-R OUT (REC) jacks, and you notice distortion
or low volume during playback from other components, try
turning on the recording component.
6
Press TONE CONTROL on the front panel
repeatedly to select "BASS" or "TREBLE"
and then press BASS/TREBLE +/– to adjust
the corresponding frequency response level.
TONE CONTROL
• Select "BASS" to adjust the low-frequency
response.
• Select "TREBLE" to adjust the high-frequency
response.
Notes
• Speaker and headphone adjustments are stored
independently.
• When "TONE BYPASS" (see page 55) is set to "AUTO",
and "BASS" and "TREBLE" are set to 0 dB, audio output
automatically bypasses the tone control circuitry of this
unit.
• If you increase or decrease the high-frequency or low-
frequency sound to an extreme level, the tonal quality of
the surround speakers may not match that of the front left
and right speakers.
• TONE CONTROL is not effective when the component
connected to the MULTI CH INPUT jacks is selected as
the input source (see page 25).
24
+
or VOLUME
–
BASS/TREBLE
7
Press PROGRAM l / h on the front panel
repeatedly (or press one of the sound field
program selector buttons on the remote
control repeatedly) to select the desired
sound field program.
The name of the selected sound field program appears
in the front panel display.
See page 31 for details about sound field programs.
l
Front panel
2CH STEREO
1
STANDARD
5
A SPEAKERS
9
Remote control
The Roxy Thtr
Currently selected
surround field program
Notes
• Choose a sound field program based on your listening
preference, not merely on the name of the program.
• When you select an input source, this unit automatically
selects the last sound field program used with the
corresponding input source.
• Sound field programs cannot be selected when the
component connected to the MULTI CH INPUT jacks is
selected as the input source (see page 25).
• When sampling frequencies higher than 48 kHz are input,
this unit is automatically set to the "STEREO" mode.
• To display information about the currently selected input
source in the front panel display, see page 28 for details.
h
PROGRAM
or
MUSIC ENTERTAIN MOVIE
2 3 4
5CH STEREO
6 7 8
B NIGHT STRAIGHT
0 +10 ENT.