Yamaha RX-V359 Owner's Manual page 30

PLAYBACK
Selecting the input modes
This unit comes with a variety of input jacks. Do the
following to select the type of input signals you want to
use.
y
• We recommend setting "INPUT MODE" to "AUTO" in most
cases.
• You can adjust the default input mode of this unit by using the
"INPUT MODE" parameter in "INPUT MENU" (see page 55).
Notes
• To play DTS-encoded CDs when using a digital audio
connection, be sure to set "INPUT MODE" to "DTS".
• Depending on the player, DTS decoding may not be performed
correctly even if you make a digital connection between this
unit and the player.
1
Press INPUT l / h on the front panel to
select the desired input source.
2
Press INPUT MODE on the front panel
repeatedly to select the desired input mode.
INPUT MODE
Currently selected
VCR V-AUX DTV/CBL
DVD
Currently selected
input source
AUTO
Automatically selects input signals in
the following order:
1) Digital signals
2) Analog signals
DTS
Selects only digital signals encoded in
DTS. If no DTS signals are input, no
sound is output.
ANALOG
Selects only analog signals. If no
analog signals are input, no sound is
output.
Note
When "INPUT MODE" is set to "AUTO", this unit
automatically switches to the appropriate decoder if a Dolby
Digital or DTS signal is detected.
26
INPUT
input sources
DVD MD/CD-R TUNER CD
AUTO
Currently selected
input mode
Adjusting speaker levels during
playback
You can adjust the output level of each speaker while
listening to a music source. This is also possible when
playing sources input at the MULTI CH INPUT jacks.
1
Press AMP on the remote control and then
press LEVEL repeatedly to select the speaker
you want to adjust.
AMP
• Select "FRONT L" to adjust the front left speaker
output level.
• Select "CENTER" to adjust the center speaker
output level.
• Select "FRONT R" to adjust the front right speaker
output level.
• Select "SUR. R" to adjust the surround right
speaker output level.
• Select "SUR. L" to adjust the surround left speaker
output level.
• Select "SWFR" to adjust the subwoofer output
level.
y
Once you press LEVEL on the remote control, you can also
select the speaker by pressing u / d.
2
Press j / i on the remote control to adjust the
speaker output level.
–
The control range is from +10 dB to –10 dB for the
center and surround speakers, and from 0 dB to
–20 dB for the front speakers and subwoofer.
Notes
• This operation will override the level adjustments made in
"SETUP" (see page 20).
• You cannot adjust speaker levels if "SPEAKER SET" in
"SOUND MENU" (see page 53) is set to "NONE".
• You cannot adjust the subwoofer level if "BASS" in
"SPEAKER SET" (see page 53) in the set menu is set to
"FRNT".
• If you use LEVEL to adjust speaker levels, the speaker levels
you previously set with the test tone will also change.
• If you select "SETUP" (see page 20) and then select "SET",
speaker levels change in response to any changes you make in
"SETUP".
LEVEL
TITLE
BAND
+
ENTER
A-E/CAT.
PRESET/CH