Operating Controls Countdown Timers (Cdt) - Henny Penny HC-4 Service Manual

2-15. OPERATING
CONTROLS -
COUNTDOWN
TIMERS (CDT)
These instructions are for both 13 and 5 count down timers.
Start-Up
1. Turn the power switch to the ON position.
2. The display shows the increase in temperature, indicating
the unit is heating.
3. When the preset temperature is reached, the HEAT ON LED
turns off and the display stays at the preset temperature.
Temperature Regulation
1. Press and hold the PROGRAM button.
2. The control beeps and "Prog Enter Code" shows in display.
3. Enter access code 1, 2, 3.
4. Press the INCREASE or DECREASE buttons to change the
flashing setpoint temperature.
5. Press and hold the PROGRAM button to set the temperature
and exit the programming mode.
Timer Operation
Each of the timers can be started, stopped, or cancelled, and not
affect the status of the other timers.
1. Press the desired timer button.
2. The time remaining shows in the display.
3. At end of time cycle, an alarm sounds and "0:00" is dis-
played.
4. Press the timer to stop alarm and "---" is displayed.
Press and hold an active timer to cancel.
2-13