Henny Penny HC-4 Service Manual page 22

2-15. CONTROLS -
COUNTDOWN
TIMERS (CDT)
(Continued)
2-14
Timer Regulation - All timers can be set to a different starting
time.
1. Press and hold the PROGRAM button.
2. The control beeps and "Prog Enter Code" shows in display.
3. Enter access code 1, 2, 3.
4. Press the PROGRAM button, and "---" is displayed, along
with all the timer settings.
5. Press the desired timer and the starting time flashes.
6. Press the INCREASE and DECREASE buttons to change
the starting time.
7. Press the timer button to set the new starting time, and now
a different timer button can pressed, and it's starting time
can be changed.
8. When finished setting timers, press and hold the PRO-
GRAM button to exit programming.
Exit the program mode at any time by pressing and holding
the PROGRAM button. Also, if no buttons are pressed for 2
minutes, programming is exited automatically.
Timing Through Power Down
If a power failure occurs while a timer is running, the timer re-
sumes the countdown when power is restored.