Clp-280/270: Keyboard Stand Assembly - Yamaha Clavinova CLP-270 Owner's Manual

CLP-280/270: Keyboard Stand Assembly

CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
Have a Phillips-head (+) screwdriver ready.
Remove all parts from the box. Confirm that all parts shown in the illustration are provided.
A
Connector panel
Styrofoam pads
Take out the styrofoam pads, and place A on top of the pads.
Position the styrofoam pads to protect the connector panel at
the bottom of A and the AC INLET.
B
C
D
Pedal cord
E
1.
Attach E and F to D.
1-2
1-1
AC INLET
F
6 x 25mm long screws x 4
6 x 16mm short screws x 6
4 x 14mm thin screws x 8
4 x 20mm tapping screws x 5
4 x 10mm thin screws x 2
Cord holders x 2
1-1
Secure D using the four 6 x 25mm long screws.
1-2
Remove the twist tie from the folded pedal
cord. Do not remove the twist tie located next
to the hole.
Don't discard the twist tie, you'll need it later in
step 6.
Headphone hanger
Side panel protection
(cardboard) pads x 2
AC power cord
(The shape of plug
differs depending
on locale.)
CLP-280/270 Owner's Manual
109