Setting The Program Change Map; Initial Program Change Map Settings - Boss GT-6B Owner's Manual

Setting the Program Change Map

When switching patches using Program Change messages
transmitted by an external MIDI device, you can freely set
the correspondence between Program Change messages
received by the GT-6B and the patches to be switched to in
the "Program Change Map."

Initial Program Change Map Settings

The Program Change Map set at the factory is shown below.
Program Number Bank/Patch Number
1
2
3
4
5
:
:
:
39
40
41
42
:
:
:
79
80
81
82
:
:
:
119
120
121
122
:
128
U1-1
U1-2
U1-3
U1-4
U2-1
:
:
:
U0-3
U0-4
u1-1
u1-2
:
:
:
u0-3
u0-4
P1-1
P1-2
:
:
:
P0-3
P0-4
P0-4
P0-4
:
P0-4
Chapter 10 Using MIDI
Procedure
fig.10-24
1. Press [UTILITY], then press PARAMETER [
[ ] so that "MIDI Map Select" is displayed.
fig.10-25
2. Rotate the PATCH/VALUE dial to select "Prog."
* You cannot set the Program Change Map when "Fix" is
selected (it is not displayed).
* See the following item for more on "MIDI Map Select."
3. Press PARAMETER [
appears in the display.
fig.10-26
Program Number
4. Press PARAMETER [
and rotate the PATCH/VALUE dial to set the received
Program number and the corresponding patch number.
5. Repeat Step 4 as needed, setting patch numbers to their
corresponding Program numbers, until the Program
Change Map is completed.
6. Press [EXIT] to return to the Play screen.
2
3
6 1
1,4
]
] until "MIDI Program Map"
Patch Number
] [ ] to move the cursor,
69