Setting The Timing Used For Switching Patches (Patch Change Mode) - Boss GT-6B Owner's Manual

Switching the Bank and Number
fig.09-05
2
1. Press the BANK
or BANK
desired bank.
When you switch banks, the indicator for number pedal
last pressed before pressing the BANK pedal flashes, and
the GT-6B is ready for the patch number to be specified
(the patch cannot yet be switched in this condition).
2. Press a number pedal to select the patch you want to
use.
The indicator for the selected number pedal lights up,
and the GT-6B switches to that patch.
* The delay and reverb sounds are suspended while patches are
switched.
1
pedal to select the
Chapter 9 Other Functions
Setting the Timing Used for Switching
Patches (Patch Change Mode)
This sets the timing with which the GT-6B switches to the
next patch when switching patches with the pedals.
The Patch Change mode appears only when "BANK/
NUMBER" has been chosen as the Patch Select mode.
1. Press [UTILITY], then press PARAMETER [
[ ] so that "Patch Change" is displayed.
fig.09-51
2. Rotate the PATCH/VALUE dial to set the timing for
switching patches.
Immediate:
The patch switches the instant a BANK pedal or any of
the number pedals is pressed.
Wait for a NUM.:
Although the indication in the display is updated to
reflect the change in the bank when a BANK pedal is
pressed, the patch doesn't get changed at that point. The
actual change to the newly selected patch takes place
only after a number pedal has been pressed, and a
complete bank and number combination has thus been
entered.
3. Press [EXIT] to return to the Play screen.
]
61