Adjusting The Overall Sound To Match The Usage Environment (Global); Using The Digital Out; Adjusting The Output Level From Digital Out - Boss GT-6B Owner's Manual

Chapter 8 Convenient Features of the GT-6B
Adjusting the Overall Sound to Match
the Usage Environment (Global)
The GT-6B includes a feature that allows you to change all of
the patch settings temporarily. This is called the "Global
function."
With the Global function, you can temporarily change your
settings to match those of your equipment and the operating
environment, while leaving the settings in the patches
untouched.
1. Press [UTILITY], then press PARAMETER [
[ ] to display the following screen.
fig.08-53
Global: Noise Suppressor Threshold
Global: Reverb Level
2. Rotate the PATCH/VALUE dial to change the setting's
value.
3. Repeat Steps 1 and 2 as needed.
4. Press [EXIT] to return to the Play screen.
NS Thrshold (Noise Suppressor Threshold)
-20 dB–+20 dB
Adjusts the noise suppressor threshold level settings for each
patch in a range from -20 dB to +20 dB.
This adjustment is an effective way to get equivalent output
with each of your basses when you are connecting more than
one bass.
* Set to "0 dB" when using this in individual patch settings.
* This has no effect on patches in which the noise suppressor is
turned off.
Revrb Level (Reverb Level) 0%–200%
Adjusts the reverb level settings for each patch in a range
from 0% to 200%.
Adjusting the reverb level is an effective way to match the
reverberation of the performance venue.
* Set to "100%" when using this in individual patch settings.
* This has no effect on patches in which reverb is turned off.
58

Using the Digital Out

Digital signals are output from the DIGITAL OUT connector
on the rear panel. You can connect this directly to the digital
in connector of a digital recorder or other device and record
with no degradation in sound quality.
fig.08-10
]
Adjusting the Output Level
from DIGITAL OUT
With the GT-6B, you can adjust the output level of DIGITAL
OUT independently of the analog output level.
1. Press [UTILITY], then press PARAMETER [
[ ] so that "Digital Out" is displayed.
fig.09-52
2. Rotate the PATCH/VALUE dial to set the digital output
level.
Valid settings: 0–200
* Raising the level too high may cause clipping of the signal
within the unit. Check the meter (p. 59) or otherwise monitor
the signal while setting this to an appropriate level.
3. Press [EXIT] to return to the Play screen.
DIGITAL IN
]