Using The Test Tone Oscillator - Yamaha AW 1600 Owner's Manual

The OSC page of the UTILITY screen lets you send the signal of the AW1600's built-in test oscil-
lator (the test tone oscillator) to the desired bus.
To access this page, repeatedly press the Work Navigate
section [UTILITY] key or hold down the [UTILITY] key
and use the CURSOR [ ]/[
1 2
This page contains the following items.
1 WAVEFORM
Selects one of the following signals for output from the
oscillator.
• OFF button.......................Oscillator is off
• 100Hz button ...................100 Hz sine wave
• 440Hz button ...................440 Hz sine wave
• 1kHz button .....................1 kHz sine wave
• 10 kHz button ..................10 kHz sine wave
• NOISE button...................White noise
When you turn on a button, the oscillator output will
immediately be sent to the specified bus. Use the
buttons to specify the bus to which the signal will be sent.
HINT
• If the LEVEL knob is raised when you output the oscillator signal,
a high volume level may be produced suddenly. Be sure to lower
the LEVEL knob before you switch on the oscillator.

Using the test tone oscillator

] keys.
34
6 5 7
3 – 6
Using the test tone oscillator
B LEVEL knob
Adjusts the output level of the oscillator.
C AUX 1/2 buttons
Send the oscillator output to AUX buses 1/2.
D EFF 1/2 buttons
Send the oscillator output to effect buses 1/2.
E BUS L R button
Sends the oscillator output to the L/R bus.
F ST L R button
Sends the oscillator output to the stereo bus.
G Level meter
Indicates the output level of AUX 1/2, effect bus 1/2, and
the L/R bus.
NOTE
• Sine waves and white noise have a higher sound pressure than
they perceptually appear. These signals may damage your speak-
ers if played at a high volume, so please use caution.
AW1600 Owner's Manual
14
167