Connecting The Ac Adaptor; Turning The Power On/Off - Yamaha AW 1600 Owner's Manual

When connecting the included AC adaptor (PA-300), you
must first connect it to the DC IN jack of the AW1600, and
then to the AC wall outlet. After connecting the AC adap-
tor to the AW1600, wrap the cable around the hook as
shown in the diagram. This will prevent the cable from
being accidentally pulled out, causing the AW1600 to
unexpectedly lose power.
You must use the following procedure to switch the power
of the AW1600 between ON and STANDBY. If you fail to
follow this procedure, the internal hard disk or your exter-
nal monitor system may be damaged.
■ Turning the power on
In a system that includes the AW1600, turn the power of
each device on in the following order.
1
External devices such as audio sources and effect
processors connected to the input/output jacks of
the AW1600
B
The AW1600 itself
C
The monitor system connected to the AW1600's out-
put jacks
CAUTION
• Before you turn on the power, make sure that the AC adaptor is
firmly connected to the AW1600 and to the AC outlet. If the
power is disconnected while the AW1600 is being used, the
AW1600 itself or the hard disk may be damaged.
When you turn on the power of the AW1600, an opening
screen will appear, and then the following screen will
appear.
■ Turning the power off (shut down)
In a system that includes the AW1600, turn the power of
each device off in the following order.
1
The monitor system connected to the AW1600's out-
put jacks
B
The AW1600 itself
C
External devices such as audio sources and effect
processors connected to the input/output jacks of
the AW1600
When turning off the power of the AW1600, you must
perform the following "shut-down" procedure.
Connecting the AC adaptor • Turning the power on/off

Connecting the AC adaptor

Turning the power on/off

1
2
3
4
In the Work Navigate section located in the
upper left of the top panel, press the
[SONG] key several times to access the fol-
lowing SHUTDOWN page.
Press the [ENTER] key located in the mid-
dle right of the top panel.
A popup window will ask you whether you want to
save the current song.
Using the CURSOR [ ]/[
in the upper right of the top panel, move the
cursor (the blinking area in the screen) to
the YES button if you want to save the cur-
rent song, or to the NO button if you do not
want to save it. Then press the [ENTER] key.
When the "Now safe to turn off..." message
appears, turn off the [POWER] switch
located on the rear panel.
IMPORTANT
• If you turn off the power of the AW1600 without perform-
ing the above shutdown procedure, not only will any
unsaved changes be lost, but you also risk damaging the
data on the hard disk, and damaging or drastically short-
ening the lifespan of the hard disk itself and the internal
CD-RW drive. Please use caution.
CAUTION
• A small amount of electrical current is flowing even when
the power is in STANDBY mode. If you will not be using
the AW1600 for an extended period of time, be sure to dis-
connect the AC adaptor from your AC outlet.
AW1600 Owner's Manual
1
] keys located
11