Tuning Operation; Automatic Tuning; Manual Tuning - Yamaha EMX-100RDS Owner's Manual

TUNING OPERATION

CD CHANGER RECEIVER EMX–100RDS
DISC
1 2 3
STANDBY/ON
PHONES
CD
1 2
1 2
6 7
6 7
A B
TIME PROG
MODE REPEAT RANDOM
DISC SKIP
CENTER/REAR
TEST FLAT
/DELAY
MUSIC
LEVEL
STANDBY/ON
SLEEP
VOLUME
2 1
3, 2 2
INPUT SELECTOR VOLUME
VCR/LD-TV/CD/TUNER/TAPE•MD/AUX
OPEN/
CLOSE
DISC
CHANGE
FREQ PS/PTY/RT/CT MODE PTY SEEK START
RANDOM REPEAT TIME MEMORY AUTO/MAN'L
PROGRAM
HOUR MIN TIME ADJ TIMER
PTY SELECT PRESET/TUNING/BAND A/B/C/D/E PTY SELECT
MUSIC
MIC MIC MIXING
USER MEMORY DISPLAY
MIN MAX
4, 3 3
3 4 5
3 4 5
8 PRESET
8 9 0
C D E
+
I0
OPEN/CLOSE TUNER 1
STOP PLAY/PAUSE
INPUT
PROGRAM USER
DISPLAY
Normally, if station signals are strong and there is no
interference, quick automatic-search tuning (Automatic
tuning) is possible. However, if signals of the station you
want to select are weak, you must tune to it manually

(Manual tuning).

Automatic tuning

1
Select the tuner by turning the INPUT SELECTOR until
"TUNER" appears on the display.
2
Select the reception band [FM or AM (MW or LW)] by
pressing the PRESET/TUNING/BAND button confirming
it on the display.
* Do not select a preset tuning mode (in which
"PRESET" lights up on the display.)
3
Press the AUTO/MAN'L button so that "AUTO" appears
on the display.
(In this mode, stations are received in stereo or monaural
automatically.)
4
Press the button to tune to a higher frequency, or
press the button to tune to a lower frequency.
(When tuned in to a station, "TUNED" will light up on the
display.)
5
If the station where tuning search stopped is not the
desired one, follow step 4 again.
* If the tuning search does not stop at the desired station,
change to the Manual tuning method as described below.
* STEREO indicator will light up when an FM stereo
broadcast with sufficient signal strength is received.
Manual tuning
1 1
Follow steps 1 and 2 of the Automatic tuning method.
2 2
Press the AUTO/MAN'L button so that "AUTO"
disappears from the display.
(In this mode, stations are received in monaural.)
3 3
Press and hold the
frequency, or press and hold the
lower frequency.
Release it just before reaching the desired frequency,
and then press it repeatedly until the desired frequency
appears.
(When tuned in to a station, "TUNED" will light up on the
display.)
Note
If you tune in to an FM station manually, it is received in
monaural automatically to increase the signal quality.
Note
Pressing the TUNER input selector button on the remote
control transmitter switches the tuner from a normal tuning
mode to a preset tuning mode and vice versa.
E-23
button to tune to a higher
button to tune to a