Speaker Balance Adjustment - Yamaha EMX-100RDS Owner's Manual

SPEAKER BALANCE ADJUSTMENT

SPEAKERS
CENTER/REAR
REAR R CENTER L REAR
MAINS
REAR SINGLE
CENTER :8 MIN./SPEAKER
REAR :4 MIN./SPEAKER
REAR SINGLE :8 MIN./SPEAKER
SEE OWNER'S MANUAL FOR CONNECTION.
AC OUTLET SPEAKERS
FRONT
R L
UNSWITCHED
100W MAX.
6 MIN./SPEAKER
SEE OWNER'S MANUAL FOR CONNECTION.
CD CHANGER RECEIVER EMX–100RDS
DISC
1 2
STANDBY/ON
PHONES
1
1 2
1 2
6 7
6 7
A B
TIME PROG
MODE REPEAT
DISC SKIP
CENTER/REAR
TEST
/DELAY
4
LEVEL
SLEEP
2
CENTER
MODE
NORMAL
PHANTOM
AM
GND
AUDIO SIGNAL
AUX TAPE•MD LD•TV VCR SUBWOOFER
IN OUT IN OUT
75
FM
VIDEO SIGNAL UNBAL.
L LD•TV VCR MONITOR
OUT CENTER
OUT IN OUT
MODE
NORMAL
R
PHANTOM
AUDIO SIGNAL VIDEO SIGNAL
INPUT SELECTOR
VCR/LD-TV/CD/TUNER/TAPE•MD/AUX
OPEN/
CLOSE
DISC
CHANGE
3
FREQ PS/PTY/RT/CT MODE PTY SEEK START
RANDOM REPEAT TIME
PROGRAM
HOUR MIN
PTY SELECT PRESET/TUNING/BAND A/B/C/D/E
MUSIC
MIC
USER MEMORY DISPLAY
3
CD
3 4 5
3 4 5
8 PRESET
8 9 0
C D E
+
I0
3
TUNER
RANDOM OPEN/CLOSE
STOP PLAY/PAUSE
INPUT
1
FLAT
MUSIC PROGRAM USER
STANDBY/ON
DISPLAY
5
VOLUME
This procedure lets you adjust the sound output level balance
between the front, center, and rear speakers using the built-in
test tone generator. When this adjustment is performed, the
sound output level heard at the listening position will be the
same from each speaker. This is important for the best
performance of the built-in Dolby Pro Logic surround decoder.
The adjustment of each speaker output level should be
done at your listening position with the remote control
transmitter. Otherwise, the result may not be satisfactory.
Before operation
Set the CENTER MODE switch on the rear panel of this unit
to the position suitable for your speaker system configuration.
(Refer to page 7 for details.)
NORMAL (For 5 speaker configuration):
ANTENNA
Select this position when you use the center speaker.
PHANTOM (For 4 speaker configuration):
Select this position when you do not use the center
speaker. The center sound will be output from the left
and right front speakers.
1
Press the STANDBY/ON switch to turn the power on.
2, 5
2
Turn the VOLUME control counterclockwise to decrease
the volume to minimum.
3
VOLUME
Press the PROGRAM button once or more so that "
PRO LOGIC" lights up on the sound field program
indicator.
MEMORY AUTO/MAN'L
TIME ADJ TIMER
4
PTY SELECT
Press the TEST button.
* "TEST" flashes on and off on the display.
MIC MIXING
MIN MAX
5
Press the VOLUME + (up) button to increase the volume.
You will hear a test tone (like pink noise) from the left front
speaker, then the center speaker, then the right front
speaker, and then the rear speakers, for about two seconds
each. The display changes as shown below.
* The test tone from the left rear speaker and the right rear
speaker will be heard at the same time.
E-14
(L and R)