Agilent Technologies TwisTorr 305 FS User Manual page 139

Where:
P = XXX W is the current power supplied to the pump
T = XX °C is the current temperature of the pump
XXXX Hz is the current frequency of rotation of the pump. This value is set
by default to 1010 Hz but can be modified by the user according to needs,
proceeding as described in the "PROGRAMMING" paragraph. The unit of
measurement (HZ / Krpm, default = Hz) is selected by the user from the
INPUT/OUTPUT->SPED menu.
If the SOFT-START function (PUMP SETTING menu → SOFTSTART is
active and the pump is ramping, indication of the speed of rotation is
replaced with a bar-graph that indicates the soft-start step in course and
the total number of steps to be performed. On completion of the soft-start
ramp, the bar-graph is replaced with indication of the frequency of rotation
of the pump
Pressing twice, the following is obtained:
N
Where:
NORMAL: indicates the operating regime of the pump
XXXHz: see description "Pressing once" Measures key
I=X.XXA: indicates the current absorbed by the pump
V= XXX V: indicates the pump driving voltage
Pressing 3 times, the following is obtained:
P
TwisTorr 305 FS Remote Controller User Manual / 87-901-059-01
O R M A L
I = X . X
= X X X W
X . X X
Technical Information
How to Use by Front Panel
X
X A V =
X
E - Y Y m
8
X X X H z
X X X V
X X X H z
B a R
139/190