1,000.4X Errors - 525-Sheet Feeder Faults; 1,0Xx.6X Errors - 525-Sheet Feeder Program Faults - Xerox PHASER 8500 Service Manual

Error Messages and Codes

1,000.4x Errors - 525-Sheet Feeder Faults

1,0XX.6x Errors - 525-Sheet Feeder Program Faults

3-8
1,001.46: The upper 525-sheet feeder had an overcurrent condition. The lift
motor or clutch may be shorted.
1,002.47: The lower 525-sheet feeder had an overcurrent condition. The lift
motor or clutch may be shorted.
Troubleshooting Procedure for for 525-Sheet Feeder
Step Questions or Actions
1 1. Unplug all connectors to the feeder.
2. Remove the feeder and inspect the
connector.
3. Replace any damaged connectors either
on the feeder or engine.
4. Reseat and reconnect the feeder.
Did this correct the problem?
Inspect the Pick Rollers in the feeder
2
tray(s).
Are the rollers damaged, dirty, or not
moving freely?
TRun the Tray [3]/[4] Pick Clutch test.
3
Does the clutch operate correctly?
4 Run the Tray [3]/[4] Lift Motor test.
Does the motor operate correctly?
5 Check the feeder wiring to the Electronics
Module (J390).
Is the wiring defective?
1. Reseat the printer on the feeder.
2. Ensure ground integrity (see "Ensuring Ground Integrity" on page 4-65).
3. Reset NVRAM.
4. Replace the feeder.
Phaser 8400/8500/8550/8560 Color Printer Service Manual
Yes No
Complete. Go to Step 2.
Replace the Go to Step 3.
Pick
Assembly.
Go to Step 4. Replace the
feeder.
Go to Step 5. Replace the
feeder.
Replace the Replace the
wiring and go feeder.
to Step 3.