Xerox PHASER 8500 Service Manual page 166

General Troubleshooting
4-36
Tilt Drive (Continued)
R# Definition
2 Pre Standby peak
Magnitude (pm
ticks)
3 Post Wipe Peak
Location ()
4 Post Wipe peak
Magnitude (pm
ticks)
This test raises the lift plate to verify motion and sensor operation. If the test is
requested for a tray not installed, an "Option Not Detected" message appears.
Tray 2, Tray 3, Tray 4, Lift Plate Drive
Typical
Value
R# Definition (8400)
0 Tray Configuration
1 Start Peak Power
(watts)
2 Slack Take-up Time
(sec)
3 Average Lift Power
(watts)
4 Lift Contact Time
(sec)
5 Lift Time (sec)
6 Stall Power (watts)
Typical Typical
Value Value (8500/
(8400) 8550/8560)
-5100 to -150 to
-500 -20
1400 to -450 to 150
4150
-4000 to -130 to 25
-75
Typical
Value (8500/
8550/8560)
Phaser 8400/8500/8550/8560 Color Printer Service Manual
Actions
Reports the pm motor
following error at the pre
standby peak location.
Reports the distance around
the tilt cam from the tilt
engage position to the post
wipe peak.
Reports the pm motor
following error at the post
wipe peak location.
Actions
Reports the tray status
(present, plate not lifted, etc.).
See Paper Path Status test for
a description of the
configuration encoding.
Reports the highest peak
during the first quarter of the
lifting interval.
Reports the interval between
the initial power min (when the
plate is not yet engaged), and
the point where the lifting
power becomes a constant.
Reports the average power
over the center ¾ of the lifting
interval.
Reports the interval from the
motor start time until the
required lift power starts to
increase due to the initial
contact with the Nudger Roller.
Reports the interval from the
motor start time until plate
lifted is indicated.
Reports the average stall
power during the overlifting
interval.