Service Parts Disassembly
8-24
12.
Remove two screws securing each end of the Transfix Load Module to the
chassis.
Transfix Load Module
13.
Remove the Transfix Load Module by rotating the bottom in and pulling it
forward.
Note
The Transfix Load Module is a very tight fit, remove carefully.
Replacement Note
Place a small amount of Rheolube 768 grease (P/N 070E00890) in
the groove on the end of each Transfix Load Arm before reattaching
the spring hooks.
After installing the Exit Module, perform the Wiper Alignment
procedure on page 6-2. The printer may report error 7,009.4x if the
Wiper Assembly is misaligned.
Transfix Load Module
Phaser 8400/8500/8550/8560 Color Printer Service Manual
s8500-090
s8500-092