Table of Contents
Advertisement
Please note that after finishing a printing job (and no other print job is sent to the printer the heating
elements will keep their temperature for approximately 6 minutes. After 6 minutes the heating elements
are powered OFF.
4.4.3 Operating the Pressure Rollers
When you want to switch the up and down movement of the pressure rollers follow the steps below.
Press the [F4] key on the operation panel.
Step 1 :
The printer works as follows.
I)
Status of the printer
The pressure rollers have been lowered
The MEDIA SET lamp turns off.
The pressure rollers have been raised.
The MEDIA SET lamp turns on (orange).
Notes
You can also switch the up and down movement of the pressure rollers using the foot switch instead of the
operation panel.
4.4.4 Print Mode Check
Use the following procedure to check the print mode currently set.
Press the [ENTER] key on the operation panel.
Step 1 :
The following information is displayed on the operation panel for three seconds.
I)
Line 2
Line 3
Line 4
No.
Position
Description
1
Line 2
The printing quality is displayed.
2
Line 3
The interlace method is displayed.
3
Line 4
The printing direction is displayed.
When the printing mode display closes, the product changes to its normal status.
Step 2 :
8265/8290/8365/8390 User Guide
Operation after the [F4] key has been pressed
The pressure rollers are lifted
The MEDIA SET lamp will turn on (orange).
The pressure rollers are lowered.
The MEDIA SET lamp will turn off.
Reference
Refer to 'Printing quality menu'
Refer to 'InterLace Setup menu'
Refer to 'Printing direction menu'
4 Printer Operation
87
Advertisement
Table of Contents
