Table of Contents
Advertisement
4
Adjusting the Link
Assembly
No Parts Required
Procedure
1.
With the rake mounted and secured on the
traction unit, raise the attachment.
2.
Measure the gap between the heavy washer and
the shoulder of the lift yoke on the attachment
adapter as shown in
Note:
The link is adjusted correctly if you
measure a gap—1.5 to 2 mm (0.060 to 0.080
inch) between the heavy washer and the lift-yoke
shoulder
(Figure
Figure 10
1. Jam nut
2. Adjustment nut
3. 1.5 to 2 mm (0.060 to
0.080 inch)
3.
If the gap is not correct, loosen the jam nut and
tighten or loosen the adjustment nut on the link
assembly as needed to change the gap
10).
Figure
10.
10).
4. Lift-yoke shoulder
5. Heavy washer
Product Overview
1. Attachment adapter
2. Handle
g220790
(Figure
6
Figure 11
3. Lift arm
4. Broom
g003463
Advertisement
Table of Contents
