Maintenance; Maintenance Safety; Recommended Maintenance Schedule(S) - Toro Reelmaster 6700-D Operator's Manual

Maintenance

Note:
Determine the left and right sides of the machine from the normal operating position.

Maintenance Safety

•
Before adjusting, cleaning, servicing, or leaving
the machine, do the following:
– Park the machine on a level surface.
– Move the throttle switch to the low-idle position.
– Disengage the cutting units.
– Lower the cutting units.
– Ensure that the traction is in neutral.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all moving parts to stop.
– Allow machine components to cool before
performing maintenance.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
After the first 50 hours
After the first 200 hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
Every 150 hours
Every 200 hours
Maintenance Procedure
• Check the torque of the wheel nuts and bolts (after the first 1 to 4 hours of operation
and then after 10 hours of operation).
• Change the engine oil and oil filter.
• Change the planetary gear drive oil.
• Change the rear axle lubricant.
• Inspect the seat belt(s) for wear, cuts, and other damage. Replace the seat belt(s) if
any component does not operate properly.
• Check the operation of the interlock switches.
• Check the engine oil level.
• Drain water or other contaminants from the water separator.
• Check the tire pressure.
• Remove debris from the rear screen, oil cooler, and radiator (more frequently in
dirty conditions).
• Check and clean the cooling system.
• Check the hydraulic fluid level.
• Check the hydraulic lines and hoses.
• Check the reel-to-bedknife contact.
• Check the electrolyte level (if the machine is in storage, check it every 30 days).
• Grease the bearings and bushings (and immediately after every washing).
• Inspect and tighten the cooling system hoses and connections.
• Check the condition and tension of the alternator belt.
• Change the engine oil and oil filter.
• Check the torque of the wheel nuts and bolts.
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.
•
Use jack stands to support the machine or
components when required.
•
Carefully release pressure from components with
stored energy.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Replace all worn or damaged decals.
•
To ensure safe, optimal performance of the
machine, use only genuine Toro replacement
parts. Replacement parts made by other
manufacturers could be dangerous, and such use
could void the product warranty.
30