Pushing Or Towing The Machine; Hydraulic Solenoid Valve Functions - Toro Reelmaster 6700-D Operator's Manual

1. Rear tie-down
Pushing or Towing the
Machine
In an emergency, you can move the machine
by actuating the bypass valve in the variable
displacement hydraulic pump, and then pushing or
towing the machine.
Important:
Do not push or tow the machine faster
than 3 to 4.8 km/h (2 to 3 mph) because internal
transmission damage may occur. The bypass
valve must be open whenever you push or tow
the machine.
1. The bypass valve is located on top of variable
displacement pump
valve 90°, in either direction, to open and allow
oil to bypass internally.
Note:
You can now move the machine slowly
without damaging the transmission.
1. Bypass valve
Figure 33
(Figure 34). Rotate the
Figure 34
2. Close the bypass valve before starting the
engine.
Important:
the bypass valve open will cause the
transmission to overheat.
Note:
Do not exceed 7 to 11 N∙m (5 to 8 ft-lb)
torque to close the valve.
Hydraulic Solenoid Valve
Functions
Use the list below to identify and describe the different
functions of the solenoids in the hydraulic manifold.
Each solenoid must be energized to allow function
to occur.
g004555
Solenoid
MSV1
MSV2
SV4
SV3
SV5
SV1
SV2
SV 6
SV 7
SV8
g019460
29
Running the engine with
Front reel circuit
Rear reel circuit
Lift front wing cutting units
Lift front center cutting unit
Lift rear cutting units
Pressurize raise/lower
hydraulic circuit
Direction: ON = Raise,
Left rear wing cutting unit
Right rear wing cutting unit
Function
OFF = Lower
Load holding