Adjusting The Throttle - Toro Reelmaster 6700-D Operator's Manual

Figure 52
1. Oil filter
3. Add oil to the crankcase.

Adjusting the Throttle

1. Position the throttle lever forward so that it stops
against the seat base slot.
2. Loosen the throttle cable connector on the lever
arm at the injection pump
g019471
1. Injection pump lever arm
3. Hold the injection pump lever arm against the
high idle stop and tighten the cable connector.
Note:
When tightened, the cable connector
must be free to swivel.
4. Torque the locknut, used to set the friction
device on the throttle lever, to 4 to 6 N∙m (40
to 55 in-lb). The maximum force required to
operate the throttle lever should be 80 N (20 lb).
37
(Figure 53).
Figure 53
2. Connector
g019472