Printer Power-On Procedure - Xerox WorkCentre Pro 75 Operator's Manual

Operator Guide

Printer power-on procedure

DocuTech/DocuPrint 75/90 and DocuPrint 75 MX
When the printer is on, the power-on/power-off indicator glows
green.
The printer must be switched on by pressing a switch on the
printer. The printer cannot be powered on from the DocuSP Print
Services interface that runs on the controller. The printer power
switch is shown in Figure 4-3.
Because this switch rocks back to its center position each time it
is pressed in either direction, you cannot determine whether the
printer is on by looking at the switch position.
To power on the printer:
1. Locate the white on/off switch on the right side of the printer.
2. Press the switch toward the back of the printer.
3. Confirm that the power-on/power-off indicator glows green.
Figure 4-3. Printer power-on
After powering-on, jobs will not print until the Fuser is ready and
the network connections are established. The system is usually
ready for network printing within 7 minutes.
Maintenance
4-3