Table of Contents
Advertisement
Things to
Check Before
You Call For
Service
01021568
15
If you unexpectedly experience changes in your water, make these simple checks before calling your Cul-
ligan deal er. One of the following conditions may be the reason for your interruption of service.
Important
If any of the following conditions is found, the water conditioner should be man u al ly recharged according
to instructions on
page 12
after you have corrected the problem.
Power Supply
Check your power supply cord. Is it plugged fully into the electric outlet? Be certain that the outlet is not
controlled by a wall switch which has been turned off. Plug in the transformer then reset conditioner to
proper time of day.
Blown Fuse
Check the house fuse or circuit breaker panel. Replace a blown-out fuse or reset an open circuit breaker.
Power Failure
Any interruption in your power supply or time changes - such as daylight savings - will disrupt your condi-
tioner's recharge schedule by causing the timer to run off-schedule. Reset timer to proper time of day.
Bypass Valves
Check to see if they are in the proper position. Cul-Flo-Valv® Bypass, if used, should be in the "Service"
position (see
page
17). If hand valves are used, see that inlet and outlet valve are opened and that the
bypass valve is closed.
No Water
If you aren't getting any water flow at all, make sure your water supply is work ing. Open a tap ahead of
the conditioner (outside tap) to see if you have any water pressure. If you have water pressure, check the
bypass valve. If it is in the Service position, put it into the bypass and call your Culligan dealer for service.
Increased Usage
Guests, family additions, new water-using appliances, etc., all will result in more water usage and will
require more capacity from your conditioner. You can re pro gram your recharging schedule by following
the directions on
page
13. Call your Culligan dealer for advice and save a service call.
Advertisement
Table of Contents
