Things To Check Before You Call Service; Power Supply; Power Failure - Culligan Gold Series Owner's Manual

Things to
If you unexpectedly experience changes in your water, make these simple checks before calling your
Culligan dealer. One of the following conditions may be the reason for your interruption of service.
Check Before
You Call For
Service
Important
If any of the following conditions is found, the water conditioner should be manually recharged
according to instructions on page 6 after you have corrected the problem.

Power Supply

Check your power supply cord. Is it plugged fully into the electric outlet? Be certain that the outlet
is not controlled by a wall switch which has been turned off. Plug in the transformer then reset
conditioner to proper time of day.
Blown Fuse
Check the house fuse or circuit breaker panel. Replace a blown-out fuse or reset an open circuit
breaker.

Power Failure

Any interruption in your power supply or time changes - such as daylight savings - will disrupt your
conditioner's recharge schedule by causing the timer to run off-schedule. Reset timer to proper time of
day.
Bypass Valves
Check to see if they are in the proper position. Cul-Flo-Valv ® Bypass, if used, should be in the "Push
for Service" position. If hand valves are used, see that inlet and outlet valve are opened and that the
bypass valve is closed.
No Water
If you aren't getting any water flow at all, make sure your water supply is working. Open a tap ahead
of the conditioner (outside tap) to see if you have any water pressure. If you have water pressure,
check the bypass valve. If it is in the Service position, put it into the bypass and call your Culligan
dealer for service.
Increased Usage
Guests, family additions, new water-using appliances, etc., all will result in more water usage and
will require more capacity from your conditioner. You can reprogram your recharging schedule by
following the directions on pages 7 - 9. Call your Culligan dealer for advice and save a service call.
9