Siemens SITRANS F Series Operating Instructions Manual page 127

Volume: m
kl, ML, BBL42
Flow rate: m
CFH, BBL42/s, BBL42/min, BBL42/h, BBL42/d
The MAG 8000 CT format for all regions is:
● m
To ensure selection of correct conversion factor, see unit conversion table in appendix.
All measurement units are printed on a label affixed to the display (except the European
version). Some meter sizes have a factor included to secure the 8 digit display value will not
overrun after short time of operation. Manual configuration of new units is allowed. A new
sticker showing the new settings must then be affixed to the display.
Protected parameters
The following parameters are protected (see also parameter lists in appendix):
MAG 8000 Standard / MAG 8000 CT
Parameter no. Parameter name
- New password
5 Sensor tube diameter
7 Meter No.
8 Totalizer unit
9 Flow unit
10 Qn (Q3)
300 Totalizer unit factor
301 Flow unit factor
302 Pipe size
321 Calibration date
323 Calibration factor
325 Sensor offset
SITRANS FM MAG 8000
Operating Instructions, 03/2020, A5E03071515-AH
, m × 100, L × 100, Gallon, G × 100, G × 1000, MG, CF × 100, CF × 1000, AF, AI,
3 3
/min, m /h, m /d, L/s, L/min, L/h, ML/d, GPS, GPM, GPH, GPD, MGD, CFS, CFM,
3 3 3
for totalizer and m /h for flow rate
3 3
MAG 8000 CT (additionally)
Parameter no. Parameter name
100 Actual date and time
101 Totalizer 1
102 Totalizer 2
201 Alarm configuration list
206 Battery alarm limit
303 Operation excitation frequency
305 Decimal point place
310 Flow direction totalizer 1
312 Flow direction totalizer 2
327 Adjustment factor
328 Low flow cut-off
332 Empty pipe impedance
Flow Tool
C.5 Unit selection
127