Installing A Scsi Or Sata Hard Drive - HP DL360 Reference And Troubleshooting Manual

50 HP ProLiant DL360 Generation 4 Server Reference and Troubleshooting Guide
The SCSI ID for each hot-plug hard drive is set automatically to the next
sequential ID number in a series beginning with ID0.
If only one SCSI hard drive is used, install it in the bay with the lowest
number.
Hot-plug hard drives must be Ultra320 SCSI types. Mixing these types with
other drive standards degrades the overall performance of the drive
subsystem.
Drives must be the same capacity to provide the greatest storage space
efficiency when drives are grouped together into the same drive array.

Installing a SCSI or SATA Hard Drive

1. Power down the server ("Powering Down the Server" on page 25).
2. Remove the existing hard drive blank or hard drive from the drive bay
("Removing a Hard Drive Blank" on page 49).
3. Install the hard drive.
4. Determine the status of the hard drive from the hot-plug hard drive LEDs
("Hot-Plug SCSI Hard Drive LEDs" on page 19).
IMPORTANT: SATA hard drive LED functionality and hot-plug
capability are not supported currently.
NOTE: Depending on the model purchased, the server or hard drive
may look slightly different than the illustration.