Assembling The Trimmer / Brushcutter; Mounting The Loop Handle - Stihl FSA 130 R Instruction Manual

English
If one LED glows red continuously: the battery
is either too hot or too cold. Allow the battery
to warm up or cool down gradually at an
ambient temperature of about 50 °F to 68 °F
(10 °C to 20 °C).
If all 4 LEDs flash red: the battery has a
malfunction and must be replaced. Do not
attempt to charge, use or store the battery.
10.2.2 Power Tool Status
The same LEDs on the battery will indicate the status of the
power tool.
If three LEDs glow red continuously: the power tool motor is
too hot. Allow the motor to cool down.
If three LEDs flash red when you activate the trigger switch:
the power tool has an electrical malfunction. Do not operate
the power tool. Have it checked by an authorized STIHL
servicing dealer before use or storage.
For troubleshooting information, @ 23.
10.2.3 Charge Status
The LEDs on the battery also show the battery's state of
charge.
To determine the battery's state of charge:
1
26
► Press the button (1) on the battery.
The LEDs on the battery will glow or flash green for about
5 seconds and indicate the state of charge (see
illustration).
For example:
If four green LEDs glow continuously: full charge.
If one green LED is flashing: less than 20 % charge.

11 Assembling the Trimmer / Brushcutter

11.1 Mounting the Loop Handle

WARNING
To reduce the risk of injury from loss of control, ensure that
the loop handle is properly and securely mounted before
starting work.
To mount the loop handle:
► Switch off the power tool, @ 15.2.
► Remove the connecting cord from the trimmer, @ 14.2.
80-100%
60-80%
40-60%
20-40%
0-20%
► Position one clamp (4) in the loop handle (3).
► Position the other clamp (6) against the underside of the
drive tube (5) and line up the holes in the loop handle and
clamps.
11 Assembling the Trimmer / Brushcutter
1
2
3
4
5
6
7
0458-725-8221-A