National Instruments PCI-1200 User Manual page 90

time-lapse measurement, 3-24
timing requirements for GATE, CLK, and
OUT signals (figure), 3-26
ground-referenced signal sources
differential connections, 3-10
purpose and use, 3-7
recommended input configurations
(table), 3-8
single-ended connections (NRSE
configuration), 3-13
H
help
professional services, B-1
technical support, B-1
I
IBF signal (table), 3-27
INL (integral nonlinearity), A-4
input configurations. See analog input
configuration
installation
hardware installation, 2-1
software installation, 2-1
unpacking the NI PCI-1200, 1-4
instrument drivers, B-1
instrumentation amplifier
figure, 3-6
purpose and use, 3-6
theory of operation, 4-6
integral nonlinearity (INL), A-4
interval scanning DAQ operation
description, 3-21
signal timing (figure), 3-22
theory of operation, 4-8 to 4-9
INTR signal (table), 3-27
© National Instruments Corporation
I/O connector
exceeding maximum ratings
(caution), 3-1
pin assignments (figure), 3-2
K
KnowledgeBase, B-1
L
LabVIEW application software, 1-1
LabWindows/CVI application software, 1-3
M
manual. See documentation
mode 1 input timing, 3-28
mode 1 output timing, 3-29
mode 2 bidirectional timing, 3-30
multichannel scanned data acquisition, 4-9
multiplexers, analog input, 4-6
mux counters, 4-6
N
National Instruments
customer education, B-1
professional services, B-1
system integration services, B-1
technical support, B-1
worldwide offices, B-1
NI-DAQ driver software, 1-3
noise, system, A-5
NRSE input
configuration, 2-5
definition (table), 2-4
recommended input configurations
(table), 3-8
single-ended connections for
ground-referenced signal sources, 3-13
I-5
Index
NI PCI-1200 User Manual