Signal Connections; I/O Connector - National Instruments PCI-1200 User Manual

Signal Connections

I/O Connector

Caution You should not externally drive DIO lines while the computer is powered off;
doing so can damage the computer. NI is not liable for any damage resulting from signal
connections that exceed these maximum ratings. Connections, including connecting power
signals to ground and vice versa, that exceed any of the maximum ratings of input or output
signals on the NI PCI-1200 may damage the NI PCI-1200 and the computer.
© National Instruments Corporation
This chapter describes how to make input and output signal connections to
the NI PCI-1200 through the device I/O connector and details the I/O
timing specifications.
The I/O connector for the NI PCI-1200 has 50 pins that you can connect to
50-pin accessories.
Figure 3-1 shows the pin assignments for the NI PCI-1200 I/O connector.
3-1
3
NI PCI-1200 User Manual