Network; Network Information; Wi-Fi - Denon CEOL RCD-N10 Owner's Manual

Contents Connections

Network

To use this unit by connecting it to a home network (LAN), you must configure network settings.
If you set up your home network (LAN) via DHCP, set "DHCP" to "On". (Use the default setting.) This allows this unit to use your home network (LAN).
When assigning an IP address to each device manually, you need to assign an IP address to this unit using the "IP Address" settings, and enter
information about your home network (LAN) such as the gateway address and subnet mask, etc.

Network Information

Displays network information.
Friendly Name / Connection / SSID (Wi-Fi Signal Strength) / DHCP /
IP Address / MAC Address (Ethernet) / MAC Address (Wi-Fi)
Front/Top
Rear panel
panel
Playback Settings

Wi-Fi

The Wi-Fi function can be stopped to prevent noise that affects the sound
quality. Using a wired LAN to connect this unit to the network enables
playback with a high sound quality.
Enabled
(Default):
Disabled:
Bluetooth
Stopping Bluetooth function reduces a source of noise that affects sound
quality, enabling higher sound quality playback.
Enabled
(Default):
Disabled:
96
Remote control
unit
Tips
Enables the Wi-Fi function.
Disables the Wi-Fi function.
Enables the Bluetooth function.
Disables the Bluetooth function.
Index
Appendix