Table of Contents
Advertisement
Operation
7. When approaching the end of painting, activate
the Do Not Fill button
preventing the pump from filling unnecessarily.
8. When finished painting, release the trigger,
engage the trigger lock, turn the electrostatics off
at the gun, and put the system in Standby mode
.
9. At this point, you may perform any of the following
actions:
• Supply more paint to the system. See
Prime the Isolation System, page
• Flush and clean the system. See
Flush the System, page
• Shut down the system. See
Shutdown, page
30
. This saves paint by
29.
27.
31.
Adjust the
the Gun
Gun Fluid
Fluid and
Adjust
Adjust
the
Gun
Fluid
The gun fluid and air pressure can be adjusted on
the Home screen using Preset 0, or using one of 99
customizable configurations for different gun fluid
and air pressure settings (Preset 1 through 99).
For example, Preset 1 might use the best pressure
settings for black paint, Preset 02 might use the best
pressure settings for red paint, and Preset 99 might
be set to the lowest pressure possible to perform
a flush. For instructions on creating presets, see
Presets, page
49.
To use
use Preset
Preset 0 0 0
To
To
use
Preset
Preset 0 can be changed by the operator at any time
during operation.
1. Press the right arrow
on the menu bar.
2. Press the Enter Screen button
screen to edit the current settings.
3. Use the down arrow
field.
4. Press the numbers on the keypad to the desired
psi value.
5. Press the Enter button
The interface automatically advances to the Fluid
field.
6. Press the numbers on the keypad to the desired
psi value.
7. Press the Enter button
The interface automatically advances to the
Preset field.
8. Press the Exit Screen button
screen settings.
Note
If an operator is in Preset 1–99, and then
switches to Preset 0, Preset 0 will reflect the
previous settings.
and Air
Air Settings
Settings
and
Air
Settings
until Home appears
to enter the
to navigate to the Air
to register the value.
to register the value.
to exit the
3A7370B
Advertisement
Table of Contents
