Preface - Siemens SIMATIC PCS 7 CPU 410-5H System Manual

Preface

1.1 Preface
Purpose of this manual
This manual represents a useful reference and contains information on operator inputs,
descriptions of functions, and technical specifications of the CPU 410-5H Process
Automation.
For information on installing and wiring this and other modules in order to set up an
automation system, refer to Manual
Basic knowledge required
This manual requires general knowledge of automation engineering.
Moreover, it is assumed that the readership has sufficient knowledge of computers or
equipment similar to a PC, such as programming devices, running under the Windows XP,
Windows Server or Windows 7 operating system. The PCS7 Readme includes information
on which operating system is suitable for your PCS7 configuration. The CPU 410-5H is
configured using the PCS 7 software, and you should thus be familiar in the handling of this
software.
In particular when operating a CPU 410-5H system in potentially explosive atmospheres, you
should always observe the information on the safety of electronic control systems provided in
the appendix of Manual
Scope of the manual
The manual is relevant to the following components:
● CPU 410–5H Process Automation; 6ES7 410-5HX08-0AB0 firmware version V8.1 and
higher
Approvals
For details on certifications and standards, refer to Manual
Module Data
specification for the entire S7-400.
CPU 410-5H Process Automation
System Manual, 09/2014, A5E31622160-AB
Automation System S7-400, Hardware and Installation
, Chapter 1.1, Standards and Certifications. Here you will also find the technical
Automation System S7-400, Hardware and Installation
S7-400 Automation System,
1
.
.
15