The System States Of The Fault-Tolerant System; Table 7- 2 Overview Of System States Of The Fault-Tolerant System - Siemens SIMATIC PCS 7 CPU 410-5H System Manual

7.2.2

The system states of the fault-tolerant system

The system states of the fault-tolerant system result from the operating states of the two
CPUs. The term "system state" is used as a simplified term which identifies the concurrent
operating states of the two CPUs.
Example: Instead of "the master CPU is in RUN and the standby CPU is in LINK-UP mode"
we say "the fault-tolerant system is in link-up mode".
Overview of system states
The table below provides an overview of the possible states of the fault-tolerant system.
Table 7- 2
System states of the fault-tolerant
system
STOP
STARTUP
Single mode
Link-up
Update
Redundant
HOLD
CPU 410-5H Process Automation
System Manual, 09/2014, A5E31622160-AB
Operator controls and operating modes of the CPU 410-5H
Overview of system states of the fault-tolerant system
Operating states of the two CPUs
Master
STOP
STARTUP
RUN
RUN
RUN
RUN
HOLD
7.2 System states of the redundant CPU 410-5H
Reserve
STOP, power off, DEFECTIVE
STOP, power off, DEFECTIVE, no
synchronization
STOP, ERROR-SEARCH, power off,
DEFECTIVE, no synchronization
STARTUP, LINK-UP
UPDATE
RUN
STOP, ERROR-SEARCH, power off,
DEFECTIVE, no synchronization
109