Table of Contents
Advertisement
REASSEMBLY AND ADJUSTMENT
FUJICA GS645
4.
Adjustment of shutter setting
Adjustment of wire
o
Adjust two eccentric pins (3- 49) to adjust set value.
[Ideal set position]
Release the shutter, watch the gap between the set lever (5- 33) and base plate
(5- 60), and set the gap to 1 mm from the base plate.
Make sure that the shutter can be set with a sufficient space for both the infinite
and minjmum distance sides.
[When shutter set is unsatisfactory at the minimum distance side]
o
Check the set lever of the slider for slackness, and bend as shown in the right
hand figure to adjust.
o
When the slackness is excessive, replace the set lever with a new one.
o
When the adjustment is completed, and the wire is too long, cut it with a cutter.
o
Be sure that the wire does not come out from the large pulley.
o
The wire must have an extra space against the eccentric pin.
o
Apply Alonalpha to the wire edge so that it will not get loose.
o
Make sure that the wire is not damaged or bent sharply.
-20-
Advertisement
Table of Contents
