Table of Contents
Advertisement
REASSEMBLY AND ADJUSTMENT
FUJICA GS645
o
T- mode
When the lever (4 -19) is pushed from the outside, the release lever moves causing
the shutter to be opened in a half way.
The shutter does not operate to close because the shutter set lever is locked by the
slider in the shutter charged position.
When the shutter release button is pressed, allowing the slider to run, the set
lever operates, causing the shutter blade to close.
The shutter is not released.
o
When the shutter is charged completely but the shutter cannot be released or
slider does not run as the shutter release button is pressed
(occasional occurrences are also included).
{}
The shaft holder portion of the large pulley assembly (3- 42) is heavy.
Repair:
Clean the shaft.
Do not use grease.
o
The slider runs but the shutter blade does not open
(occasional occurrences are also included)
Insufficient shutQ. charging.
Repair:
The shutter must be charged with a sufficient setting strokes
at both the minimum distance ana infinity sides.
When the shutter charging is minus at the minimum distance
side, refer to II -
4
above.
-28-
Advertisement
Table of Contents
