Table of Contents
Advertisement
DISASSEMBLY AND REASSEMBLY
FUJICA GS645
3.
Film advance mechanism assembly (3 - 1)
o
The following instructions for removal of the film advance mechanism assembly
are for your reference only.
A new method may be developed and used.
In this case, however, it must be kept in your mind that the wire assembly
(5- 37) which operates when charging the shutter is associated with the film
advance mechanism.
Be careful not to damage or fold the wire.
a.
Remove the bellows from the housing side after removing four set screws
(6- 46).
b. Remove the wire from the pulley base assembly (5-7) by moving the set lever
(5- 33) so that the wire is loosened.
c.
Remove set screws (3- 125X3) and screw (3- 126).
d. With the film chamber door and zero reset lever opened, remove the film advance
mechanism assembly (3- 1) upward.
e. When separating the wire from the film advnace mechanism assembly (3- 1),
loosen two eccentric pins (3- 49) on the large pulley.
When the wire is removed once, do not use it again but replace the wire
assembly (5- 37) with a new one.
For wire assembly setting, refer to II- 4 below.
-6-
Advertisement
Table of Contents
