Table of Contents
Advertisement
DISASSEMBLY AND REASSEMBLY
FUJICA GS645
1.
Top cover assembly (1 -1)
o
Remove the film advance lever assembly (1 - 33) after removing the set screw
(1 - 30).
o
Raise the top cover assembly (1 - 1) to remove it after removing three set screws
(1-27, 1-28 and 1-29).
NOTE:
Pay attention on the two lead wires extended to the shoe (1- 4).
[REASSEMBLY]
o
Be sure to set the film selector knob (1 - 9) to the 120 film side before installing
the top cover.
If the top is installed with the film selector knob set to 220
film side, the selector lever in the film advance mechanism assembly (3- 1) will
be bent.
o
Arrange the associated lead wires properly so that they are not seen through the
viewfinder window, and install the top cover.
o
Carefully combine the top cover with the terminal cover (7- 40) and cover frame
(7 . 50).
o
Carefully install the lock plate (1- 37) so that it will not be overlapped on the
lever (3 - 29).
o
Check the shutter release for the operating stroke.
The desirable operating stroke
of the shutter release is shown below.
0.3 to 0.5 mm
More than 0.5 mm
More than 0.3 mm
--11'-*
---;t----
LED turns on
shutter is released
-2-
Advertisement
Table of Contents
