Table of Contents
Advertisement
DISASSEMBLY AND REASSEMBLY
FUJICA GS645
4.
Housing assembly (4- 10)
o
Remove four set screws (6- 46) from the rail surface.
o
Wind up the film advance lever, and fold the linkage mechanism in a half way.
o
Remove two screws (5- 17) with a pin- face spanner.
NOTE:
When reinstalling these screws, be sure to lock them with screw locking
agent.
o
Remove two set screws (5- 18) with a flat head screw driver.
NOTE:
When reinstalling these screws, be sure to lock them with screw locking
agent.
o
Remove the gate (5- 76) and two links (5- 67), and take out the housing
assembly (4- 10) carefully.
NOTE:
Pay attenion on the lead wires extended from the shutter assembly.
o
When replacing the shutter assembly with a new one.
Remove the housing assembly (4 -10) as described above, take out the lead wires
from the camera body, remove the rear lens assembly ( 4 - 57) and hold ring
(4- 56) with a pin face spanner, and then, take out the shutter assembly.
[REASSEMBLY]
£e
careful-Rot-to OOld the l€ad wire in-between----the---hellu_ws and housing when
installing the bellows.
If
the lead wire is held, the helicoid will not operate smoothly.
When the helicoid is operated to the position for the minimum distance, the lead
wires must have an extra length.
-10-
Advertisement
Table of Contents
