Siemens SINAMICS S120 Equipment Manual page 219

Article number
Max. cable length
3) 4)
(total of all motor cables and DC link)
- Shielded
- Unshielded
Degree of protection
Dimensions
- Width
- Height
- Depth
Frame size
Weight
Recommended fuse
5)
- Number per phase (connected in parallel)
- Rated current
- Frame size acc. to IEC 60269
Minimum short-circuit current
The specified power loss is the maximum value at 100% capacity utilization. The value in normal operation is lower.
1)
Total sound pressure level of Active Interface Module and Active Line Module.
2)
The cable lengths are valid for use in the IT system. When used in the TN system, the cable lengths are shortened to
3)
30% of the specified value.
When used in the TN system and when operating the connected Motor Modules with increased pulse frequency, you
4)
will receive the permitted cable lengths upon request.
To achieve a UL-approved system, it is absolutely essential to use the fuse types specified in the table.
5)
Minimum current required for reliable triggering of the protective devices.
6)
Air-cooled chassis power units
Manual, 07/2019, 6SL3097-4AE00-0BP9
6SL3330– 7TG35–8AA3
m
m
mm
mm
mm
kg
kA
6)
7TG37–4AA3
2250 2250
3375 3375
IP00 IP00
503 704
1475 1480
540 550
HX JX
290 450
3NE1447-2 3NE1448-2
1 1
670 850
3 3
8.4 10.5
Line Modules
5.4 Active Line Modules
7TG41–0AA3 7TG41–3AA3
2250 2250
3375 3375
IP00 IP00
704 704
1480 1480
550 550
JX JX
450 450
3NE1436-2 3NE1438-2
2 2
630 800
3 3
16 20
217