Service Schedule - Husqvarna PT26D Workshop Manual

DELIVERY AND DEALER SERVICE

Service Schedule

The following is a list of maintenance procedures
that must be performed on the rider. Most of the
points that are not described in this workshop
manual are found in the operator's manual.
Maintenance
Check for fuel and oil leaks
Check the safety switch, seat
Check the safety switch, pedal system
Check the engine oil level (at every
refuelling)
Check the hydraulic oil level
Check the coolant level
Check / clean the engine's radiator air
intake, the radiator screen and radiators
Check fastenings (screws, nuts, etc.)
Start the engine and blades, listen for
unusual sounds
Clean under the cutting unit and belt
covers
Check for damage
Check the air pressure in the tyres
(100 kPa)
Clean thoroughly around the engine
Clean thoroughly around the
transmission
Lubricate according to the lubrication
3)
chart
Clean the air filter and empty the
particle trap
Check the blades
Change the engine oil and filter
Replace hydraulic oil filter
check the oil level
Check the tension and condition of
the belts (alternator belt, power take-
off belts, cutting unit belt)
Page Daily main-
tenance
before

-

101

101

67

109

29
65
-
-
-
-
91
-
-
-
72
96
1) 67
4) 111
and
69
84
95

= Described in this workshop manual.

= Not described in this workshop manual or the
operator's manual.

= Described in the operator's manual.
Weekly Maintenance interval hours
main-
250
tenance
after



  


  




 





500 1000 2000

19
English-
3000