Delivery And Dealer Service; Delivery Service; After The First 25 Hours; 250-Hour Service - Husqvarna PT26D Workshop Manual

DELIVERY AND DEALER SERVICE

Delivery and Dealer Service

Delivery Service

1. Attach the cutting unit.
2. Adjust the cutting unit so that its rear edge is
about 6-9 mm higher than its front edge.
3. Check the engine coolant level and anti-
freeze.
4. Check that the right amount of oil is in the
engine, hydraulic system and cutting unit's
angle gear.
5. Check and adjust the air pressure in the tyres
100 kPa / 1 bar / 14.5 PSI.
6. Connect the battery.
7. Fill with fuel and start the engine.
8. Check that the machine does not move in
neutral.
9. Check:
• Driving forwards.
• Reversing.
• Engaging the blades.
• Safety switch in the seat.
• Inductive sensor for lifting device.
• Inductive sensor for hydrostat pedals.
10. Check the engine speed.
11. Check the fastening bolts on the muffler.
12. Check that no leakage occurs (coolant,
engine or hydraulic oil) after test running
13. Inform the customer about:
14. The need and advantages of following the
service schedule.
15. The need and advantages of leaving the
machine for service every 250 hours.
16. The effects of service and maintaining a serv-
ice journal on the machine's resale value.
17. Application areas for Mulching.
18. Fill in the sales papers, etc.

After the First 25 Hours

• Replace the hydraulic oil filter.
• Change the engine oil and filter.
• Check the tension and condition of the belts
(generator and water pump belt, power-take-
off belts, cutting unit belt).
• Check the muffler screws and the wheel nuts.
• Check the muffler screws and wheel nuts.
• Check the hoses and couplings as well as oil
and fluid levels.
• Check for any leakage of water and oil.
• Adjust the cutting unit so that its rear edge is
about 6-9 mm higher than its front edge.
• Retighten and check the lock nuts (4 pcs) on
the centre connection on the hydraulic oil tank.

250-hour service

1. Change the engine oil and filter.
2. Replace the hydraulic oil filter and check the
oil level, fill up if necessary.
3. Replace the air filter, clean the cyclone
cleaner and empty the particle trap.
4. Check the tension and condition of the belts
(generator and water pump belt, power-take-
off belts, cutting unit belt).
5. Check the condition of the battery.
6. Check the oil level in the bevel gear, fill up if
necessary.
7. Check the wheel nuts.
8. Lubricate the brake cables and adjust as
necessary.
9. Check the safety functions.
10. Clean the cutting unit, under the belt covers
and under the cutting unit.
11. Clean the radiator and radiator grille with
compressed air.
12. Lubricate according to the lubrication chart.
13. Adjust the cutting unit so that its rear edge is
about 6-9 mm higher than its front edge.
14. Check the level, concentration and cooling
system's hoses.
17
English-