Repair Instructions; Removing And Refitting The Engine - Husqvarna PT26D Workshop Manual

Repair Instructions

Removing and refitting the engine

WARNING!
Hot components, allow the engine
to cool
1. Remove the engine cover.
IMPORTANT INFORMATION
Hold the bolts so that the poles are not put
under strain.
2. Release the cable connections. Remove
the battery fastening bolts. Then lift out
the battery.
IMPORTANT INFORMATION
Used engine and hydraulic oil are hazard-
ous to health and must not be disposed of
on the ground or in nature; it should always
be disposed of at a workshop or appropriate
disposal location.
Avoid skin contact; wash with soap and
water in case of spills.
3. Position the wheels fully to the left and
drain the engine oil.
4. Drain the hydraulic tank.
WARNING!
Coolant is poisonous and hazard-
ous to the environment. Handle
according to local regulations.
5. Drain the coolant.
6. Remove the air filter with rubber hoses.
7. Clean the hydraulic and fuel connections
which need to be released, as set out in
the general instructions.
8. Loosen the hydraulic hoses from the
hydraulic tank.
9. Release the console with battery discon-
nector relay and fuses from the battery
shelf. Bind up the console.
10. Release the cables from the fuel filter. Fit
the protective plugs.
REPAIR INSTRUCTIONS
Fastening bolts engine cover
Engine oil drainage
The hydraulic tank's drain plug
Coolant draining
8009-779
8009-795
8043-117
8009-884
61
English-